Fig.1Space for additionallogo if requiredTP9User InstructionsFig.2Before programming the thermostat press the + & – AND & buttonssimultaneously to reset the unit (Fig.1)Setting the Clock and Day1) CLOCK - Press PROG (Fig.2) to begin programmingUse + or – buttons (Fig.3) to adjust the TIME (Fig.4)2) DAY - Press PROG again (Fig.2)Use + or – buttons (Fig.3) until correct DAY is shown (MO = Monday) (Fig.5)Accepting the Factory Pre-settingsThe TP9 has pre-set times already programmed in for controlling the heatingand hot water, which often suit most people (see Table below & Fig.12 over).To accept these settings press the PROG button until the time appears in thedisplay and colon begins to flash - the unit is now in RUN mode (Fig.6).If you wish to alter these settings follow instructions below.Your installer will have set your unit to operate in one of the following modes:5/2 day - one set of programmes for weekdays and another for weekends24 hour - one set of programmes for the whole weekProgramming your CENTRAL HEATINGFor Days 1-5 (weekdays)a) Press PROG (Fig.2) 3 times to show the 1st pre-set time and temperature(Event 1 Days 1,2,3,4,5) (Fig.7)b) Use + or – buttons to adjust the TIME (press and hold to change in 10 minincrements)c) Use or buttons to adjust the TEMPERATURE (Fig.8)d) Press PROG (Fig.2) to move to next preset time & temp (Event 2) (Fig.9)e) Repeat steps b, c & d for programming Events 3, 4 5 & 6For Days 6-7 (weekends) Press PROG (Fig.2) to show 1 st pre-set time and temperature (Event 1 Days6-7) (Fig.10) Repeat steps b, c and d above to programme time and temperatyureevents for the weekendNB. Left hand LED will be lit when the Central Heating programme is runningFig.7Fig.5Fig.3Fig.4Fig.8Mon-Sun (24 hour mode)Mon-Fri (5/2 day mode) Sat-Sun (5/2 day mode)Event Time Temp°C Event Time Temp°C1 06.30 20 1 07.00 202 08.30 16 2 10.00 163 12.30 19 3 12.00 194 13.30 16 4 14.00 165 17.30 21 5 17.00 216 22.30 16 6 22.30 16Fig.6Fig.9Fig.10