Danfoss TP4000 Range User Manual
Also see for TP4000 Range: Installation guideUser guideUser instructionsInstallation instructions
           | |
Danfoss Heating 7GBFRESNLGRPLCZTRHRROHULTGB1.4 Setting the ClockNote: clock is displayed in 24 hour mode.Press PROG and Λ until the time on the displayflashes.Use + or - to adjust the TIME (press and hold tochange in 10 min increments).Press PROG to enter the TIME.1.5 Running your programmeIf you are happy to use the preset programmeson page 6, you don’t need to do anything else.Your unit is now in RUN mode.2.0 Advanced2.1 Before you change the preset programmesPlease NoteThe unit must be programmed in sequence. Event times cannotbe programmed out of sequence.If you want to leave a preset time as it is, simply press PROG tomove on to the next setting.During programming, if no buttons are pressed for 2 minutes the unitwill automatically return to RUN mode, and the programme set up tothat minute will be active. |
Related manuals for Danfoss TP4000 Range
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine