Danfoss TP4000 User Instructions

Also see for TP4000 Range: User guide Installation guide User guide Installation instructions

Contents

user instructions

Danfoss TP4000 User Instructions Manual pdf 1 page image

Fig.1TP4000User InstructionsFig.2Before programming the thermostat press and release the RESET button to restartthe unit. (Fig. 1)Setting the Clock and DayThe time is set in the factory and therefore it will not normally be necessary to do thison site.Accepting the Factory Pre-settingsThe TP4000 has pre-set times already programmed in, which often suit most people(see table below).To adjust the factory pre-settings & set your own time and temperatureprogrammesa) Press PROG (Fig. 2) Until 1st pre-set time and temperature appears in display (Fig.3).b) Use + or – buttons (Fig. 4) to adjust the TIME (press and hold to change in 10 minincrements).c) Use Λ or V buttons (Fig. 5) to adjust the TEMPERATURE.d) Press PROG (Fig. 2) to move to next preset time & temp (Event 2) (Fig. 6).e) Repeat steps b, c & d for programming Events 3, 4, 5 & 6.Returning to RUN modePress PROG (Fig. 2) – the colon in the LCD display will start to flash (Fig. 7).Temporary User OverridesFig.5Fig.4Fig.6Fig.7Event Time Temp. °C1 06:30 202 08:30 153 11:30 204 13:30 155 16:30 216 22:30 15RESETFig.3Fig.9Fig.10Selection of timeor actual roomtemperature in mainLCD displayTemporaryoverride ofprogrammedtemperaturepresstogetherFrostProtectionFig.8The TP4000 has several useful overrides which can be selected without affecting thethermostat programming.• Selection of time or actual room temperature in main LCD display – press +and – together to change between settings (Fig. 8).• Temporary override of programmed temperature – press Λ or V until requiredtemperature is displayed (override will automatically cancel at beginning of nextprogrammed event) (Fig. 9).• Frost Protection – a constant low temperature can be selected whilst away fromhome - press Λ and V together (Fig.10). Then use Λ or V to select the requiredtemperature. To return to automatic programming press Λ and V togetheragain.The TP4000 is both a programmer and a room thermostat. It allows you to programmeup to 6 times and temperatures at which your heating will come on and go off eachday.

/ 2

Related manuals for Danfoss TP4000 Range