TP9000 SiUser InstructionsA. Setting the correct Time and DayFig. 1B. Accepting the Factory SettingsFig. 2Fig. 3Fig. 4Fig. 5Fig. 6Fig. 7Before beginning programming, you should reset the unit. Open the flap on the frontof the clock. Press the RESET button using a non-metallic object (e.g. end of a bic biropen top). (Fig 1)The time and date are factory set and do not need to be set.The TP9000 comes ready programmed with a set of Hot Water times and Central Heatingtimes and temperatures to suit the average household. If you wish to alter these settingsfollow instructions below.Your unit is set to operate in 7 day mode.7 day – different settings for each day of the weekPlease follow the instructions below:C. Programming your central heating - 7 day mode• A)Press the CH/HW button until the CH mode is selected (Fig 2a)• B) Press PROG to show the 1st pre-set time and temperature (Event 1 Mon) (Fig 2b)• C) Use + or – buttons to adjust the TIME (press and hold to change in 10 minincrements). (Fig 3)• D) Use Λ or V buttons to adjust the TEMPERATURE. (Fig 4)• E) Press NEXT to move to next preset time & temp (Event 2) (Fig 5)• F) Repeat steps c, d and e for programming Events 3, 4, 5 & 6.• G) to select the next day, press DAY/HOL and repeat steps c, d, and e (Fig 6)• H) repeat process as necessary to complete programming for all 7 daysTo return to normal operating mode press and hold PROG until screen returns to the currenttime. (Fig 7)(a)(b)The TP9000 is a programmable room thermostat with combined hot water timecontrol.A programmer allows you to set On and Off time periods to suit the lifestyle of theoccupier.A room thermostat works by sensing the air temperature, switching on the heatingwhen the air temperature falls below the thermostat setting, and switching it offonce this set temperature has been reached. A programmable room thermostatlets the occupier choose what times they want the heating to be on and whattemperature it should reach while it is on. It will allow you to select differenttemperatures in your home at different times of the day (and days of the week) tomeet your particular needs.The TP9000 controller is also unique in that it also controls the hot water timings inyour home.D. Programming your hot water - 7 day mode• A)Press the CH/HW button until the HW mode is selected (Fig 8)• B) Press PROG to show the 1st pre-set time (Event 1 Mon)• C) Use + or – buttons to adjust the TIME (press and hold to change in 10 minincrements). (Fig 9)• D) Press NEXT to move to next preset time(Event 2) (Fig 10)• E) Repeat steps c and d for programming Events 3, 4, 5 & 6.• F) To select the next day, press DAY/HOL and repeat steps c, d, and e (Fig 11)• G) Repeat process as necessary to complete programming for all 7 daysTo return to normal operating mode press and hold PROG until screen returns to the current time.(Fig 12)