Danfoss TP9 Installation Instructions Manual

Also see for TP9: User instructions

Contents

Danfoss TP9 Installation Instructions Manual Manual pdf 24 page image

24Running your programmeThe TP9 will control your Central Heating and Domestic Hot Watersystem in any one of three ways.To switch between the 3 operating modes press both the V andW buttons simultaneously. The display will alter as shown.1. Heating & Hot WaterAutomatically controls roomtemperature as programmed andswitches on hot water twice a day.2. Heating onlyProvides a constant low roomtemperature while the home is emptyfor extended periods.(N.B. When the unit switches the CH on,the HW will also switch on if the unit hasbeen set for linked GRAVITY operation).3. Water onlySwitches Hot Water on and off twice aday during the summer, or other timeswhen Central Heating is not needed.However, if the room temperature fallsbelow the low setting displayed, theheating will switch ON.NOTE: If the minimum temperature has been set to 16°C and youdo not want the heating to switch ON at all whilst operating in thismode, you should ask your installer to fit an extra switch to the CHoutput. He can get the information he needs to do this from ourTechnical Services Department.User InstructionsGB