Danfoss TS715 Si Installation & User's Instructions

Also see for TS715 Si: Installation & user's instructions Installation & user's instructions User instruction Operating instructions

Contents

Danfoss TS715 Si Installation & User's Instructions Manual pdf 3 page image

3Please Note:This product should only be installed by a qualifiedelectrician or competent heating installer, and should bein accordance with the current edition of the IEEE wiringregulations.Specifi cation 230V Model 24V ModelPower supply 230 Vac, ±15%,50/60 Hz24Vac, ±15%,50/60HzSwitching action 1 x SPDT voltage free, Type 1BSwitch rating 24 - 230 Vac, 3(1)ABattery back-up 24 hours minimumSetting/Running Accuracy ±1 minuteDimensions, mm (W, H, D) 135 x 88 x 32Design standard EN 60730-2-7Control Pollution Situation Degree 2Rated Impulse Voltage 2.5kVBall Pressure Test 75°CProduct specificationInstallation and SpecificationInstallation InstructionsInstallationz Remove wallplate from unit by unscrewing the two screwson the bottom edge of the unit.z From the top left hand corner of the wallplate, there mustbe clearances of at least 140 mm to the right, 15mm to theleft, 30mm above and 100mm below in order to mountthe plug-on module.