Danfoss VLT AQUA Drive FC 202 Operating Instructions Manual

Also see for VLT AQUA Drive FC 202: Service guide Installation guide Installation guide Operating guide Installation guide

7.1.8. Read-out and Programming of Indexed ParametersParameters are indexed when placed in a rolling stack.par. 15-30 AlarmLog: Error Code to par. 15-32 AlarmLog: Time contain a fault log which can be read out. Choose a parameter, press [OK], and use theup/down navigation keys to scroll through the value log.Use par. 3-10Preset Reference as another example:Choose the parameter, press [OK], and use the up/down navigation keys keys to scroll through the indexed values. To change the parameter value,select the indexed value and press [OK]. Change the value by using the up/down keys. Press [OK] to accept the new setting. Press [Cancel] to abort.Press [Back] to leave the parameter.7.1.9. Tips and tricks* For the majority of water and wastewater applications the Quick Menu, Quick Setup and Function Setups provides the simplestand quickest access to all the typical parameters required.* Whenever possible, performing an AMA, will ensure best shaft performance* Contrast of the display can be adjusted by pressing [Status] and [▲] for darker display or by pressing [Status] and [▼] forbrighter dispaly* Under [Quick Menu] and [Changes Made] all parameters that have been changed from factory settings are displayed* Press and hold [Main Menu] key for 3 seconds for access to any parameter* For service purposes it is recommended to copy all parameters to the LCP, see par 0-50 for further informationTable 7.1: Tips and tricks7.1.10. Quick Transfer of Parameter Settings when using GLCPOnce the set-up of a frequency converter is complete, it is recommended to store (backup) the parameter settings in the GLCPkeypad or on a PC viaMCT 10 Set-up Software Tool.NB!Stop the motor before performing any of these operations.Data storage in LCP:1. Go to par. 0-50 LCPCopy2. Press the [OK] key3. Select “All to LCP”4. Press the [OK] keyAll parameter settings are now stored in the GLCP indicated by the progress bar. When 100% is reached, press [OK].The GLCP can now be connected to another frequency converter and the parameter settings copied to this frequency converter.Data transfer from LCP to Frequency converter:1. Go to par. 0-50 LCPCopy2. Press the [OK] key3. Select “All from LCP”4. Press the [OK] keyThe parameter settings stored in the GLCP are now transferred to the frequency converter indicated by the progress bar. When 100% is reached, press[OK].VLT® AQUA DriveOperating Instructions 7. How to operate the frequency converterMG.20.M5.02 - VLT® is a registered Danfoss trademark 597