Danfoss VLT AQUA Drive Operating Instructions Manual

Also see for vlt aqua: Instructions Design guide Instruction manual Design guide Operating instructions

7.1.14. PC Software toolsPC Software - MCT 10All Frequency converters are equipped with a serial communication port. Danfoss provides a PC tool for communication between PC and frequencyconverter, VLT Motion Control Tool MCT 10 Set-up Software.MCT 10 Set-up SoftwareMCT 10 has been designed as an easy to use interactive tool for setting parameters in our frequency converters. The software can be downloaded fromthe Danfoss internet site http://www.vlt-software.com.The MCT 10 Set-up Software will be useful for:• Planning a communication network off-line. MCT 10 contains acomplete frequency converter database• Commissioning frequency converters on line• Saving settings for all frequency converters• Replacing a frequency converter in a network• Simple and accurate documentation of frequency converter set-tings after commissioning.• Expanding an existing network• Future developed frequency converters will be supportedMCT 10 Set-up Software supports Profibus DP-V1 via a Master class 2 connection. It makes it possible to on line read/write parameters on-line in afrequency converter via the Profibus network. This will eliminate the need for an extra communication network.Save Frequency Converter Settings:1. Connect a PC to the unit via USB com port. (Note: Use a PC, which is isolated from the mains, in conjunction with the USB port. Failure to doso may damage equipment.)2. Open MCT 10 Set-up Software3. Choose “Read from drive”4. Choose “Save as”All parameters are now stored in the PC.Load Frequency Converter Settings:1. Connect a PC to the frequency converter via USB com port2. Open MCT 10 Set-up software3. Choose “Open”– stored files will be shown4. Open the appropriate file5. Choose “Write to drive”All parameter settings are now transferred to the frequency converter.A separate manual for MCT 10 Set-up Software is available: MG.10.R2.02.The MCT 10 Set-up Software ModulesThe following modules are included in the software package:MCT 10 Set-up SoftwareSetting parametersCopy to and from frequency convertersDocumentation and print out of parameter settings incl. diagramsExt. User InterfacePreventive Maintenance ScheduleClock settingsTimed Action ProgrammingSmart Logic Controller Set-upCasade Control Config. ToolOrdering number:Please order the CD containing MCT 10 Set-up Software using code number 130B1000.MCT 10 can also be downloaded from the Danfoss Internet: WWW.DANFOSS.COM, Business Area: Motion Controls.7. How to operate the frequency converterVLT® AQUA DriveOperating Instructions60 MG.20.M4.02 - VLT® is a registered Danfoss trademark7