4.9 Final Set-up and TestTo test the set-up and ensure that the adjustable frequency drive is running, follow these steps.Step 1. Locate the motor nameplateNOTE!The motor is either star- (Y) or delta-connected (Δ). This information is located on the motor nameplate data.Step 2. Enter the motor nameplate data in this parameter list.To access this list, first press the [QUICK MENU] key, then select “Q2Quick Set-up”.1. Par. P-07Motor Power [kW]Par. P-02Motor Power [HP]2. Par. F-05Motor Rated Voltage3. Par. F-04Base Frequency4. Par. P-03Motor Current5. Par. P-06Base SpeedStep 3. Activate the Automatic Motor Adaptation (AMA)Performing an AMA will ensure optimum performance. The AMA measures the values from the motor model equivalent diagram.1. Connect terminal 37 to terminal 12 (if terminal 37 is available).2. Connect terminal 27 to terminal 12 or set par. E-03Terminal 27 Digital Input to 'No function' (par. E-03Terminal 27 Digital Input [0])3. Activate the AMA par. P-04Auto Tune.4. Choose between complete or reduced AMA. If a sine-wave filter is mounted, run only the reduced AMA, or remove the sine-wave filter duringthe AMA procedure.5. Press the [OK] key. The display shows “Press [Hand on] to start”.6. Press the [Hand on] key. A progress bar indicates if the AMA is in progress.Stop the AMA during operation1. Press the [OFF] key - the adjustable frequency drive enters into alarm mode and the display shows that the AMA was terminated by the user.VLT AQUA Low Harmonic Drive InstructionManual 4 How to InstallMG.20.T1.22 - VLT® is a registered Danfoss trademark 4-614