Danfoss VLT AutomationDrive FC 302 Programming Manual

Also see for VLT AutomationDrive FC 301: Programming guide Installation guide Operating guide Installation guide Design guide

Contents

Danfoss VLT AutomationDrive FC 302 Programming Manual Manual pdf 15 page image

2.1.1 The LCD-DisplayThe LCD-display has backlight and a total of 6 alpha-numeric lines. The display lines show the direction ofrotation (arrow), the selected set-up as well as theprogramming set-up. The display is divided into 3 sections.Top sectionshows up to 2 measurements in normal operating status.Middle sectionThe top line shows up to 5 measurements with relatedunit, regardless of status (except in the case of alarm/warning).Bottom sectionalways shows the state of the frequency converter inStatus mode.Top sectionMiddle sectionBottom sectionStatus43 RPM1.4 HzAuto Remote Running! Pwr.card temp (W29)2.9%5.44 A 25.3kW1(1)130BP074.10!Illustration 2.2 Bottom SectionThe active set-up (selected as the active set-up inparameter 0-10 Active Set-up) is shown. When programminganother set-up than the active set-up, the number of theprogrammed set-up appears to the right.Display contrast adjustmentPress [Status] and [▲] for darker displayPress [Status] and [▼] for brighter displayMost parameter set-ups can be changed immediately viathe LCP, unless a password has been created viaparameter 0-60 Main Menu Password or viaparameter 0-65 Quick Menu Password.Indicator lights (LEDs)If certain threshold values are exceeded, the alarm and/orwarning LED lights up. A status and alarm text appear onthe LCP.The ON LED is activated when the frequency converterreceives mains voltage or via a DC bus terminal or 24 Vexternal supply. At the same time, the back light is on.• Green LED/On: Control section is working.• Yellow LED/Warn.: Indicates a warning.• Flashing Red LED/Alarm: Indicates an alarm.OnWarn.Alarm130BP044.10Illustration 2.3 Indicator lights (LEDs)LCP KeysThe control keys are divided into functions. The keysbelow the display and indicator lamps are used forparameter Set-up, including choice of display indicationduring normal operation.130BP045.10Status QuickMenuMainMenuAlarmLogIllustration 2.4 LCP Keys[Status]indicates the status of the frequency converter and/or themotor. Select between 3 different readouts by pressing[Status]: 5 line readouts, 4 line readouts or Smart LogicControl.Press [Status] for selecting the mode of display or forchanging back to Display mode from either the QuickMenu mode, the Main Menu mode or Alarm mode. Alsouse [Status] to toggle single or double read-out mode.[Quick Menu]allows quick access to different Quick Menus such as QuickMenu• My Personal Menu• Quick Set-up• Changes Made• LoggingsPress [Quick Menu] to program the parameters belongingto the Quick Menu. It is possible to switch directlybetween Quick Menu mode and Main Menu mode.[Main Menu]is used for programming all parameters.It is possible to switch directly between Main Menu modeand Quick Menu mode.Parameter shortcut can be carried out by pressing down[Main Menu] for 3 seconds. The parameter shortcut allowsdirect access to any parameter.How to Programme VLT® AutomationDrive FC 301/302 Programming GuideMG33MI02 - Rev. 2013-11-20 132 2