Danfoss VLT AutomationDrive FC 360 Quick Manual

Also see for VLT AutomationDrive FC 360: Quick guide Quick guide Programming guide Programming guide Design guide

Danfoss VLT AutomationDrive FC 360 Quick Manual Manual pdf 17 page image

4.4 Wiring SchematicThis section describes how to wire the frequency converter.130BC438.173 phasepowerinputSwitch ModePower SupplyMotorAnalog OutputInterface(PNP) = Source(NPN) = SinkON=TerminatedOFF=OpenBrakeresistor91 (L1)92 (L2)93 (L3)PE50 (+10 V OUT)53 (A IN)54 (A IN)55 (COM A IN)0/4-20 mA12 (+24 V OUT)31 (D IN)18 (D IN)20 (COM D IN)10 V DC15 mA 100 mA+ - + -(U) 96(V) 97(W) 98(PE) 99(A OUT) 45(A OUT) 42(P RS485) 68(N RS485) 69(COM RS485) 610V5VS8010/4-20 mARS485RS48503+10 V DC0/4-20 mA0-10 V DC24 V DC02010504250 V AC, 3 A24 V (NPN)0 V (PNP)0 V (PNP)24 V (NPN)19 (D IN)24 V (NPN)0 V (PNP)27 (D IN/OUT) 24 V0 V0 V (PNP)24 V (NPN)0 V24 V29 (D IN/OUT)24 V (NPN)0 V (PNP)0 V (PNP)24 V (NPN)33 (D IN)32 (D IN)95P 5-0021ON(+UDC) 89(BR) 81 5)24 V (NPN)0 V (PNP)0-10 V DC(-UDC) 88RFI3)0 V250 V AC, 3 ARelay 11)Relay 2 2)4)06Illustration 4.2 Basic Wiring Schematic DrawingA=Analog, D=Digital1) Built-in brake chopper available from J1–J5.2) Relay 2 is 2-pole for J1–J3 and 3-pole for J4–J7. Relay 2 of J4–J7 with terminals 4, 5, and 6 has same NO/NC logic as relay 1.Relays are pluggable in J1–J5, and fixed in J6–J7.3) Single DC choke in J1–J5; Dual DC choke in J6–J7.4) Switch S801 (bus terminal) can be used to enable termination on the RS485 port (terminals 68 and 69).5) No BR for J6–J7.Electrical Installation Quick GuideMG06A702 Danfoss A/S © 03/2017 All rights reserved. 154 4