Danfoss VLT AutomationDrive FC 360 Quick Manual

Also see for VLT AutomationDrive FC 360: Quick guide Quick guide Programming guide Programming guide Design guide

Danfoss VLT AutomationDrive FC 360 Quick Manual Manual pdf 24 page image

5.4 Local Control Panel (LCP) OperationsVLT® AutomationDrive FC 360 supports numerical localcontrol panel (NLCP) LCP 21, graphic local control panel(GLCP) LCP 102, and blind cover. This chapter describes theoperations with LCP 21 and LCP 102.NOTICEThe frequency converter can also be programmed fromthe MCT-10 Set-up Software on PC via RS485 com-port.This software can be ordered using code number130B1000 or downloaded from the Danfoss website:www.danfoss.com/BusinessAreas/DrivesSolutions/software-download.5.4.1 Numerical Local Control PanelThe numerical local control panel LCP 21 is divided into 4functional sections.A. Numeric display.B. Menu key.C. Navigation keys and indicator lights (LEDs).D. Operation keys and indicator lights (LEDs).130BC506.10Setup 1ABCD51213 14 1510111096784123MenuStatus QuickMenuMainMenuHandOnOffResetAutoOnBackOKOnWarnAlarmIllustration 5.2 View of the LCP 21A. Numeric displayThe LCD display is backlit with 1 numeric line. All data isshown in the LCP.1 The set-up number shows the active set-up and the editset-up. If the same set-up acts as both active and edit set-up, only that set-up number is shown (factory setting).When active and edit set-ups differ, both numbers areshown in the display (set-up 12). The number flashingindicates the edit set-up.2 Parameter number.3 Parameter value.4 Motor direction is shown at the bottom left of the display.A small arrow indicates the direction.5 The triangle indicates whether the LCP is in Status, QuickMenu, or Main Menu.Table 5.1 Legend to Illustration 5.2, Section A130BD135.10Setup 1234INDEXAHPVkWsrpmHz%n2n1 n3p5 p4 p3 p2 p1Illustration 5.3 Display InformationB. Menu keyTo select between Status, Quick Menu, or Main Menu,press [Menu].C. Indicator lights (LEDs) and navigation keysIndicator Light Function6 On GreenON turns on when the frequencyconverter receives power from themains voltage, a DC bus terminal, or a24 V external supply.7 Warn YellowWhen warning conditions are met, theyellow WARN LED turns on, and textappears in the display area identifyingthe problem.8 Alarm RedA fault condition causes the red alarmLED to flash and an alarm text isshown.Table 5.2 Legend to Illustration 5.2, Indicator Lights (LEDs)Commissioning VLT® AutomationDrive FC 36022 Danfoss A/S © 03/2017 All rights reserved. MG06A70255