Danfoss VLT Brook Crompton Motor FCM 300 Design Manual

Contents

Danfoss VLT Brook Crompton Motor FCM 300 Design Manual Manual pdf 34 page image

However, some parameters will be "missing",depending on the choice of configuration(parameter 100), e.g. open loop hides all the PIDparameters.In addition to having a name, each parameter is linked upwith a number which is the same regardless of theprogramming mode. In the Menu mode, the parametersare divided into groups, with the first digit of theparameter number (from the left) indicating the groupnumber of the parameter in question.Regardless of the mode of programming, a change of aparameter will take effect and be visible both in the Menumode and in the Quick menumode.3.1.12 Quick Setup via Quick MenuThe Quick Setup starts with pressing the [Quick Menu] key,which brings out the following read-out on the display:50.0 Hz SETUP1QUICK MENU X OF Y001 LANGUAGEENGLISHAt the bottom of the display, the parameter number andname are given together with the status/value of the firstparameter under Quick Setup. The first time the [QuickMenu] key is pressed after the unit has been switched on,the read-outs will always start at pos. 1 - see Table 3.6.3.1.13 Parameter SelectionThe selection of parameter is effected by means of the[+]/[-] keys. The following parameters are accessible:Pos.: No.: Parameter: Unit:1 001 Language2 200 Direction of rotation3 101 Torque characteristic4 204 Min. reference [Hz]5 205 Max. reference [Hz]6 207 Ramp up time [s]7 208 Ramp down time [s]8 002 Local/remote control9 003 Local referencePos.: No.: Parameter: Unit:10 500 Bus addressTable 3.6 Parameter Selection3.1.14 Menu ModeThe Menu mode is started by pressing the [Menu] key,which produces the following read-out on the display:50.0 HzFREQUENCY0 KEYB.&DISPLAYIllustration 3.8Line 3 on the display shows the parameter group numberand name.3.1.15 Parameter GroupsIn the Menu mode the parameters are divided into groups.Selection of parameter group is effected by means of the[<][>] keys.The following parameter groups are accessible:Group no. Parameter group0 Operation & Display1 Load & Motor2 References & Limits3 Inputs & Outputs4 Special functions5 Serial communication6 Technical functions*For information on parameter group 800 and 900 for PROFIBUS,please see the FCM Profibus manual MG03EXYY.Table 3.7Programming VLT® DriveMotor FCM Series32 MG03BA02 - VLT® is a registered Danfoss trademark33