5.2 Ordering Numbers5.2.1 Ordering Numbers: AccessoriesAccessories Description Ordering No.Mounting brackets extended 40 mm brackets 130B5771Mounting brackets Flat brackets 130B5772LCP cable Preconfectioned cable to be used between inverter and LCP 130B5776Brake resistor 1750 Ω 10 W/100% For mounting inside installation box below motor terminals 130B5778Brake resistor 350 Ω 10 W/100% For mounting inside installation box below motor terminals 130B5780VLT Control Panel LCP 102 Graphical display for programming and read out 130B1078Venting membrane, goretex Preventing condensation inside enclosure 175N2116PE termination, M20 Stainless Steel 175N2703PE termination, M16 Stainless Steel 130B5833Table 5.2 Ordering Numbers: Accessories5.2.2 Ordering Numbers: Spare PartsSpare parts Description Ordering No.Protection cover Plastic protection cover for inverter part 130B5770Gasket Gasket between installation box and inverter part 130B5773Accessory bag Spare cable clamps and screws for shield termination 130B5774Service switch Spare switch for mains or motor disconnect 130B5775LCP plug Spare plug for mounting in installation box 130B5777Main termination board For mounting in installation box 130B5779M12 sensor plugs Set of two M12 sensor plugs for mounting in cable gland hole 130B5411Control card Control card with 24 V backup 130b5783Control card Profibus Control card Profibus with 24 V backup 130b5781Control card EtherNet Control card EtherNet with 24 V backup 130b5788Control card Profinet Control card Profinet with 24 V backup 130b5794Table 5.3 Ordering Numbers: Spare PartsThe packaging contains:• Accessories bag, supplied only with order ofinstallation box. Contents:- 2 cable clamps- bracket for motor/loads cables- elevation bracket for cable clamp- screw 4 mm 20 mm- thread forming 3.5 mm 8 mm• DocumentationDepending on options fitted, the box will contain one ortwo bags and one or more booklets.Type Code and Selection Gui... VLT® Decentral Drive FCD 30276 MG04H102 - VLT® is a registered Danfoss trademark55