Danfoss VLT FC 100 Series Programming Manual
Also see for VLT HVAC Drive FC 102: Operating instructionsService guideInstallation guideInstallation guideOperating guide
                                                                                                                                                                                                                                                                                            | |
Contents
| 
3.16. Main Menu - Data Readouts - Group 163.16.1. 16-** Data ReadoutsParameter group for data read-outs, e.g. actual references, voltages, control, alarm, warning and status words.3.16.2. 16-0* General StatusParameters for reading the general status, e.g. the calculated reference, the active control word, status.16-00 Control WordRange: Function:0 * [0 - FFFF] View the Control word sent from the frequency converter via the serial communication port in hex code.16-01 Reference [Unit]Range: Function:0.000* [-999999.000 - 999999.000] View the present reference value applied on impulse or analog basis in the unit resulting from the configurationselected in par. 1-00 (Hz, Nm or RPM).16-02 Reference %Range: Function:0%* [-200 to 200 %] View the total reference. The total reference is the sum of digital, analog, preset, bus, and freeze references,plus catch-up and slow-down.16-03 Status WordRange: Function:0 * [0 - FFFF] View the Status word sent from the frequency converter via the serial communication port in hex code.16-05 Main Actual Value [%]Range: Function:0%* [-100 to +100%] View the two-byte word sent with the Status word to the bus Master reporting the Main Actual Value.16-09 Custom ReadoutRange: Function:0 * [-999999.99 to 999999.99] View the user-defined readouts as defined in par. 0-30, 0-31 and 0-32.3.16.3. 16-1* Motor StatusParameters for reading the motor status values.16-10 Power [kW]Range: Function:0.0kW* [0.0 - 1000.0 kW] View the motor power in kW. The value shown is calculated on the basis of the actual motor voltage and motorcurrent. The value is filtered, and therefore approx. 30 ms may pass from when an input value changes to whenthe data read-out values change.VLT® HVAC Drive Programming Guide 3. Parameter DescriptionMG.11.C5.02 - VLT ® is a registered Danfoss trademark 1413 |
Related manuals for Danfoss VLT HVAC Drive FC 102
Danfoss VLT FC 100 Series Programming Manual
Danfoss VLT FC 51 Series Programming Manual
Danfoss VLT Series Programming Manual
Danfoss FC 300 Series Programming Manual
Danfoss FC 51 Series Programming Manual
Danfoss VLT FC 103 Programming Manual
Danfoss VLT HVAC Series Programming Manual
Danfoss VLT HVAC Basic Drive FC 100 Series Programming Manual
Danfoss VLT FC 100 Series Manual
Danfoss VLT Programming Manual
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine