Danfoss VLT HVAC Design Manual

Also see for VLT HVAC: Instructions Operating instructions Instruction Operating instructions Instruction manual

Contents

Danfoss VLT HVAC Design Manual Manual pdf 51 page image

3 VLT HVAC Drive Selection3.1 Options and AccessoriesDanfoss offers a wide range of options and accessories for the frequency converters.3.1.1 Mounting of Option Modules in Slot BThe power to the frequency converter must be disconnected.For A2 and A3 enclosures:• Remove the LCP (Local Control Panel), the terminal cover, and the LCP frame from the frequency converter.• Fit the MCB1xx option card into slot B.• Connect the control cables and relieve the cable by the enclosed cable strips.Remove the knock out in the extended LCP frame delivered in the option set, so that the option will fit under the extended LCP frame.• Fit the extended LCP frame and terminal cover.• Fit the LCP or blind cover in the extended LCP frame.• Connect power to the frequency converter.• Set up the input/output functions in the corresponding parameters, as mentioned in the sectionGeneral Technical Data.For B1, B2, C1 and C2 enclosures:• Remove the LCP and the LCP cradle• Fit the MCB 1xx option card into slot B• Connect the control cables and relieve the cable by the enclosed cable strips• Fit the cradle• Fit the LCPA2, A3 and B3 enclosures A5, B1, B2, B4, C1, C2, C3 and C4 enclosuresVLT® HVAC Drive Design Guide 3 VLT HVAC Drive SelectionMG.11.B9.02 - VLT® is a registered Danfoss trademark 513