Danfoss VLT Series Operating Instructions Manual

Also see for VLT series: Service manual Installation guide Operating instructions Operating instructions Service manual

Danfoss VLT Series Operating Instructions Manual Manual pdf 6 page image

Several motors can be operated in a group using a hybridcable. This cable carries the DC supply voltage and theCAN bus signals. The ISD 410 servo system is designed toaccommodate up to 60 ISD 410 servomotors and consistsof:• 1 Power supply module• 1 Connection box• 1 Encoder Box• Servomotors• 1 Master• Hybrid cablesNOTEThe ISD 410 servomotors cannot be used in other servosystems from other manufacturers!Motors from other manufacturers cannot be used in theDanfoss ISD 410 servo system!2.2 TerminologyISD Integrated Servo DrivesISD servo system Complete system including all components.ISD master Control system hardwareISD master system Control system hardware and softwareISD servo drive ISD servomotor with hybrid cableTable 2.2 Terminology2.3 Purpose of the Operating InstructionsThe purpose of these operating instructions is to describethe Danfoss ISD power supply module exclusively in thecontext of a Danfoss ISD 410 servo system.These operating instructions contain information about:• Installation• Commissioning• Operation• Troubleshooting• Maintenance and repairThese operating instructions are intended for use byqualified personnel. Read these operating instructions infull in order to use the servo system safely and profes-sionally, and pay particular attention to the safetyinstructions and general warnings. These operatinginstructions are an integral part of the ISD power supplymodule. Keep these operating instructions available withthe servo system at all times.Compliance with the information in the operatinginstructions is a prerequisite for:• Trouble-free operation• Recognition of product liability claimsTherefore, read these operating instructions beforeworking with the power supply module!The operating instructions also contain important serviceinformation. The operating instructions should therefore bekept close to the power supply module.2.4 Additional ResourcesAvailable documents for the ISD 410 servo system:Document ContentsVLT® ISD 410Servomotor OperatingInstructionsInformation about the commissioningand operation of the servomotorsVLT® ISD Encoder BoxOperating InstructionsInformation about the commissioningand operation of the encoder boxVLT® ISD Connection BoxOperating InstructionsInformation about the commissioningand operation of the connection boxVLT® ISD Power SupplyModule OperatingInstructionsInformation about the commissioningand operation of the power supplymoduleVLT® ISD 410 DesignGuideInformation about the constructionand commissioning of the ISD 410servo systemTable 2.3 Available Documents for the ISD 410 Servo SystemTechnical literature for Danfoss drives is also availableonline at http://www.danfoss.com/BusinessAreas/DrivesSo-lutions/Documentations/Technical+Documentation.htm.Firmware updates may be available. When firmwareupdates are available, they can be downloaded from thewww.danfoss.com website. For further information see theVLT® ISD 410 Design Guide.Introduction VLT® ISD Power Supply Module Operating Instructions6 MG75H102 - VLT® is a registered Danfoss trademark22