Danfoss m2 Manual
Also see for m2: Instructions
                                    | |
Contents
| 
8 Manual RS.8A.N5.0 © Danfoss 10-007 m Version 3.11Operation via the Key PadPoint Overview To view the status of all the points at the same time, select the Point Overviewoption from the Main Menu. The Point Overview screen is displayed. Thisscreen shows each activated point as one of the following icons, depending onthe point condition.- active point in normal condition - an inhibited point- active point in an alarm condition - a point in defrost- a point in defrost pulldownNote: If there are more than 0 points in the system extra lines of points will bedisplayed underneath the first 0 points (up to a maximum of 99 points).To select a point, the cursor box can be positioned around a point symbol byusing the ‘ ‘ or ‘ ‘ keys. As each point is selected the point number and itscurrent status/temperature is displayed in the window on the right hand side ofthe screen.When the Overview Scan mode is selected, the cursor will cycle round all theactivated points in turn, pausing for 3 seconds on each one so that the currentstatus may be read.To display more details of a particular point, position the cursor box around thepoint required and press ‘↵’. The Point Detail screen will be displayed.Note: If a point has a local offset applied to it, this will be indicated by thepresence of the offset icon at the left of the Point Readout window.To continuously view the status of a single point, either select the Point Detailoption from the Main Menu or select a point on the Point Overview and press‘↵’. The Point Detail screen is displayed.Use the ‘ ’ key to select the next point or the ‘ ’ key to select the previouspoint. The point number is displayed in the upper left-hand corner of thescreen and the current status is displayed in large text in the centre of thescreen. The text and symbols displayed in the window on the right hand side ofthe screen are as follows:Indicates the upper alarm limit setting. When the ofthe symbol is scrolling, it indicates that the upper alarmlimit has been exceeded.Indicates the alarm delay in minutes. When the hand ofthe clock rotates, it indicates that the point is in the alarmcondition and the delay has not yet expired.Indicates the lower alarm limit setting. When the partof the symbol is scrolling, it indicates that the lower alarmlimit has been exceeded.Indicates the input point type.this indicates whether the point has been setup for 'Local'or 'Remote' alarms.- Local - alarms are raised based onm alarm settings.- Remote - alarms are raised based oncontroller alarm settings.Point Detail |
Related manuals for Danfoss m2
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine