258Figure 4-79Click to draw the rule.Click OK to complete the rule setup.For detailed setups, please refer to chapter 4.8.3.1.1 motion detect for detailed information.4.8.3.3.2 Global ConfigFrom main menu->Setup->Event->Behavior analytics->Global, user may go to the global configurationinterface. See Figure 4-80. Channel: Please select a channel from the dropdown list. Preset: Select a preset you want to set the rule. Please note, you need to add a preset first,otherwise, user maynot see the preset dropdown list. If there is no preset, user may draw a rule incurrent channel. Calibration zone: Click Add area , user may draw a calibration zone at the left pane of the interface. Select a zoneand then click Delete zone button; user may remove the selected zone. Select gauge type (vertical/level), user may set the corresponding length. User may draw three tiltgauges and one horizontal gauge at the left pane of the interface. Select Width/Height and then click Verify, user may draw a line in the calibration zone, and then usermay see its actual length. Update preset: Click it to get the latest preset setup.
