DataBay AVE-301T User Manual

Also see for AVE-301R: User manual User manual

Contents

DataBay AVE-301T User Manual Manual pdf 11 page image

VGA and Audio Cat-X AV Extender11 / 16Plug two ends of UTP cable to Transmitter and Receiver’s RJ45 SYSTEM LINKports, the Receiver’s connected monitor and speaker should work now and theLEDs above RJ-45 port should remain ON. You can adjust the “FOCUS” and“GAIN” control of Receiver to have the best VGA display.(5) Function Test: After above installation, you will be able to broadcast theAV signal to Receiver’s connected monitor and speaker.(6) Problem and Solving: If you find unstable image or audio problems afterinstallation, please confirm following list or contact your direct vendor forfurther assistance:a. Check if PC’s VGA resolution and frequency over the limit of monitordisplay, if so, please change the VGA configuration from WindowsControl panel.b. Try to connect Monitor and speaker directly to a PC, and ensure thebasic function of these devices.c. When using LCD or same type monitor, there might have some imageoffset or blinking, please adjust the position, clock or phase of the LCDmonitor, or simply press Auto Adjust / Tune to have a better imagesolution.5.3 AVE-300 Multi-Port Model: Installation and Operation:(1) Site Selection: In your first time installation, place Transmitter near thePC or AV devices; you can use rack mounting kit to fix the system box.(2) Connecting Monitor and Speaker: Plug power adapter to the Transmitterand connect monitor and speaker to “VGA/AUDIO OUT” port. The POWERLED will turn on green to indicate the POWER ON status and ”ACTIVE” LEDsshould turn off to indicate the unconnected status. Then, prepare VGAand audio cables to connect the signal from your AV device to the“VGA/AUDIO IN” port of Transmitter box.Rack Mounting Kit forMulti-Port Unit