DRAGON™15855.11.2 Copy DRAGON M-SeriesProcedure:c Using the slave reader and its OM-DRAGON™ cradle, follow the initializationprocedure in chapter 4 of this manual or from the Quick Reference Manual.d With the master DRAGON M (correctly configured reader), read the CopyConfiguration barcode below. Then place it onto an OM-DRAGON™ cradlewithin 10 seconds. The reader will beep indicating the configuration has beencopied.The configuration will be simultaneously sent over the RS232 interface of theOM-DRAGON™. If this causes undesired effects disconnect the RS232 cablebetween the PC and OM-DRAGON™ during this process.Copy Configurationi ;; ki ;; ki ;; k$+ZZ0$-e With the slave DRAGON M, read the Get Configuration barcode below. Thenplace it onto the same OM-DRAGON™ cradle used in the step above. Theslave reader's address will not be changed.Get Configurationi ;;ki ;;ki ;;k$+ZZ2$-The configuration will be copied from the master to the slave DRAGON M. Theslave DRAGON M signals the end of the procedure with a series of beeps. It isnow ready to be used with its own OM-DRAGON™ cradle.f Repeat the procedure above to configure other slave readers. TheOM-DRAGON™ can continue to configure slave readers until it receivesanother command or data.
