Datalogic MX-E Series Hardware Manual
                                                                                                                        | |
Contents
| 
Connecting the Camera MX-E Series Hardware GuideDatalogic S.r.l. 32Connecting the CameraWARNING: Never wire M1xx or E1xx Camera Strobe Outputs in parallel with M1xx, E1xx, M2xx, or M3xx CameraStrobe Outputs. This will damage the cameras.M1xx and E1xx Camera ConnectionTo connect M1xx and E1xx camera trigger signals and strobe outputs, use cable 606-0674-xx (6pin Hirose Male to DB9) with terminal block 661-0399.NOTE 1: If Camera Trigger In requires a sinking signal, set the Software Trigger Event to Rising Edge. If it requires asourcing signal, set the Software Trigger Event to Falling Edge.NOTE 2: If Strobe Trigger Output requires a sinking signal, set the Strobe Trigger Output to Falling Edge. If it requires asourcing signal, set the Strobe Trigger Output to Rising Edge.NOTE 3: Disconnecting the camera will turn on some strobe lights.Terminal Name Signal NotesOptional CameraPowerDO NOT USE Do NOT apply power to this terminal ifpower is supplied by Power overEthernet (PoE ; enable/disable inVPM-Settings )Optional CameraPower GroundDO NOT USE Not required if ground is supplied byPower Over Ethernet (PoE; enable/disablein VPM-Settings )I/O Ground I/O GroundTrigger In** Camera Trigger In 0 to +24 VDC recommendedMaximum +30 VDCAs sinking inputOff: 0 to +1.4 VDCOn: +2.2 to +24 VDC; 5 to 15 maAs sourcing input (see Trigger Pullup +VCC)Off: +2.2 to +24 VDC; 5 to 15 maOn: 0 to +1.4 VDCTrigger Pullup+VCC**Trigger In Pullup - use ifTrigger In needs sourc-ing (see Note 1 below)+24 VDC recommendedMaximum +30 VDC(**Block contains 1.6k Ohm 1W resistor between Trigger In andTrigger Pullup +VCC)Strobe OutputPullup +VCC*Strobe Supply Voltage -use if Strobe TriggerOutput needs sourcing(see Note 2 below)Based on Strobe requirement (optional)Max: +30 VDC; 50 ma(*Block contains 1.6k Ohm 1W resistor between Strobe TriggerOutput and Strobe Output Pullup +VCC)Strobe TriggerOutput*Trigger Out to Strobe(see Note 3 below)DO NOT APPLY ANY VOLTAGE DIRECTLY TO THIS OUTPUT.DO NOT WIRE OUTPUTS IN PARALLEL. |
Related manuals for Datalogic E1 Series
manualsdatabase
Your AI-powered manual search engine