Datalogic PowerScan PBT7100 Quick Reference Manual

Also see for POWERSCAN PBT7100 guide: Quick reference guide Product reference guide Product reference guide

Contents

16 PowerScan® PBT7100 Cordless Imaging Reader• The reader may not be programmed to output your barcode data properly. For example,you scan “12345” and the host displays “A12345B.” Reprogram the reader with theproper Data Editing selections. Reference the PRG.• The reader won’t read your barcode at all.• Scan the part number barcode on the back of this manual or other known-good barcodesamples. If the reader reads sample barcodes, check that your target barcode is readable.• Verify that your barcode symbology is enabled. See the PRG.• If you aren’t sure what programming options have been set in the reader, or if you want thefactory default settings restored, go to the Resetting the Standard ProductDefaults section of this manual and scan the standard factory default settings barcode.• The reader sounds other than a standard “Good Read” beep followed by an “Acknowledge 1”beep when reading a barcode (indicating the barcode has been read and properly transmit-ted).• Verify the reader is linked to and within range of its Base Station.1. Typically, both of these beep indications are active in the reader. To enable/disable theseindications, reference the PRG.

/ 20

Related manuals for Datalogic POWERSCAN PBT7100 guide