Datalogic SG2 BASE Series Instruction Manual
Also see for SG2 BASE Series: Instruction manualOriginal instructionsInstruction manualInstruction manual
                                                      | |
Contents
| 
SG2 BASE Instruction Manual348.1. General information and useful dataSafety MUST be a part of our conscience.The safety devices fulfil their safety function only if they are correctly installed, in accordance with theStandards in force.If you are not certain to have the expertise necessary to install the device in the correct way,DATALOGIC AUTOMATION Customer Service is at your disposal to carry out the installation.The device uses fuses that are not self-resetting. Consequently, in presence of short-circuits causingthe cut-off of these fuses, both units shall be sent to DATALOGIC AUTOMATION service department.A power failure caused by interferences may cause the temporary opening of the outputs, but the safefunctioning of the light curtain will not be compromised.8.2. WarrantyDATALOGIC AUTOMATION guarantees each brand new SG2 system, under standard use conditions,against manufacturing defects in material and workmanship for a period of 36 (thirty-six) months fromthe date of manufacturing.DATALOGIC AUTOMATION will not be liable for any damages to persons and things caused byfailure to stick to the correct installation modes and device use.Warranty validity is subject to the following conditions: User shall notify DATALOGIC AUTOMATION the failure within thirty-six months from productmanufacturing date. Failure or malfunction shall not have been originated directly or indirectly by: use for unsuitable purposes; failure to comply with the intended use prescriptions; negligence, unskillfulness, wrong maintenance; repairing, changes, adaptations not made by DATALOGIC AUTOMATION personnel, tampering withthe device, etc.; accidents or crashes (even due to transportation or by force majeure causes); other causes not depending from DATALOGIC AUTOMATIONIf the device does not work, send both units (receiver and emitter) to DATALOGIC AUTOMATION.The Customer is responsible for all transport charges and damage risks or material loss duringtransport, unless otherwise agreed.All replaced products and parts become a property of DATALOGIC AUTOMATION.DATALOGIC AUTOMATION does not accept any warranty or right other than the above-describedones. No requests for compensation for expenses, activities stop or other factors or circumstancessomehow connected to the failure of the product or one of its parts to operate cannot be put forwardfor any reason.In case of problems, please contact DATALOGIC AUTOMATION Service Department:Tel.: +39 051 6765611Fax.: +39 051 6759324 |
Related manuals for Datalogic SG2 BASE Series
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine