Dataman Dataman-40Pro User Manual
Also see for Dataman-40Pro: User manual
                                                                                                    | |
Contents
| 
Note: Due to the low power consumption when in an inactivestate, the Dataman-40Pro doesn't require power switch. Whenthe power LED indicator glows with a low intensity theDataman-40Pro is in inactive mode.Connecting Dataman-40Pro to PCFor Dataman-40Pro the order of connecting the USB cable andpower supply to programmer is irrelevant.Problems related to the Dataman-40ProÙPC connectionIf you have any problems with Dataman-40Pro Ù PCconnection, see section Common notes please.Manipulation with theprogrammed deviceAfter selecting the desired part, you can insert it into the openZIF socket (the lever is up) and then close socket (the lever isdown) to begin programming. The correct orientation of theprogrammed device in ZIF socket is shown on the picture nearZIF socket on the programmer's cover. It is necessary to insertthe device into the socket and to also close the socket. Makesure not to remove the device from the socket when the LEDBUSY is on.Warning: The Dataman-40Pro programmer doesn’t protectdevices against critical situations, for example power failuresand PC failure (interrupted cable...). Moreover, a device isusually destroyed in the programming mode due to forcedinterruption of the control program (Reset or switching thecomputer off) due to removing the connecting cable, orunplugging the programmed device from the ZIF socket. Anincorrectly placed device in the ZIF socket can also causedamage.In-system serial programming byDataman-40ProFor general information, recommendations and directionsabout ISP see section Common notes / ISP please.28 |
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine