3.5 Set-upThere are various features in the ‘set-up’ menu.The following figure shows the ‘set-up’ menu:KEY BEEP OFFSET-UPREADING BEEPS OFFREADING TIMEOUT 10sSHUTDOWN TIMEOUT 2mSERIAL BAUD RATE 115kYou can scroll through the ‘set-up’ features by pressing the UP or DOWN button. You canchange the highlighted parameter by pressing the LEFT/RIGHT button.3.5.1 Reading beepsThe reading beep features enable or disable the acoustic signal when a TAG is found. Whenthe reading feature is OFF the beep is disabled, while is ON the beep is enabled.3.5.2 Key beepThe key beep enables or disables the acoustic signal when the button is pressed. When the keyfeature is OFF, the beep is disabled. When it is ON, the beep is enabled.3.5.3 Reading timeoutThe reading timeout is the maximum period of time that the reader scans for a TAG. After thisperiod the reader switches from reading mode to idle mode automatically showing the message“NO TAG FOUND”.3.5.4 Shutdown timeoutThe shutdown timeout is the maximum period of time the reader stays on while no buttons arepressed. After this period the reader switches off automatically.3.5.5 Serial baud rateThis parameter sets the speed of the serial communication through the USB interface. Thisparameter must be the same in the reader and on the PC program that attempts to receive datafrom the reader.3.6 BluetoothThe following figure shows the Bluetooth menu (refer to chapter 4.4 for details).ACTS AS CLIENT OFFBLUETOOTHACTS AS SERVER ONR-PO7470 Manual – v. 1.1 – August 2008 11