DT-6XXX IP-SPOOL Application User’s Manual – Build 12.004/13/06 Datatek Applications Inc. 19The dconn (dc) command is used to display all of the current connections into the IP-SPOOL application. The command does not require any arguments. The report shows theconnection peer for each active connection.8.15 DISPLAY JOBS IN QUEUE – DQ | DQUEUESyntax: dq | dqueueThe dq command displays all jobs in the queue assigned to the application instance.8.16 PURGE JOBS IN QUEUE - PURGESyntax: purge [ queue=] [ confirm=yes]The purge command deletes all jobs currently in the queue, where is theconfigured queue name for this instance of the application. The queue and confirmarguments are both required as shown, since the command is destructive and irreversible.8.17 DISPLAY LOG - DLOGSyntax: dlog | dlog clrThe dlog command is only visible when the application is logged in. This command isused to display the entries in the error log. An exclamation point ( ! ) that precedes a logentry denotes new entries. A double asterisk ( ** ) that precedes a log entry denotesfolding of multiple similar entries into a single line. The log file can be cleared with thecommand: dlog clr8.18 DISPLAY OF M EASUREMENTS - DMEASSyntax: dmeasThe dmeas command is only visible when the application is logged in. The command isused to display the current measurements on all of the interfaces.8.19 CLEAR M EASUREMENTS – CLR | CLEARSyntax: clr | clearThe measurements displayed with the dmeas command are aggregated until cleared. Theclr command will set all measurements to zero. The command has no arguments.
