Datavideo DN-600 Quick Start Manual

Also see for DN-600: Instruction manual

Contents

Datavideo DN-600 Quick Start Manual Manual pdf 11 page image

- 11 -Providing PowerThe DN-600 comes with an AC Adapter. Plug the output of either one into the DC Power connector locatedon the Rear Panel. It is recommended that you have a DN-600 inserted in the Bay before power up. Nothaving one at this time, does not influence normal device operation. Move the power switch to the ONposition. The DN-600 will turn on and will wait for 5 seconds for you to press the Menu key to go into HDDmode, after the wait period it will go into the VTR mode.VTR ModeFormatting the DN-600The DN-600 will format a DN-600 to handle one of three signal types; HDV (all frame rates), or NTSC DV orPAL DV. If an unformatted DN-600 is inserted, the DN-600 will recognize it and suggest it be formatted to itssignal type. If a DN-600 is inserted and is format for a signal type different than that of the DN-600, thechoice will be given to either re-format the DN-600 or set the DN-600 to the DN-600’s signal type.Organize your shootA recorded length of video between its start point and following pause or stop point is called a clip. A clip canbe as short as one frame or as long as the whole storage capacity. Clips are stored in bins; a bin isanalogous to a tape. 99 bins are made available; Clips can be added to any bin at any time as long as thereis room available. The DN-600 always displays the clip number as well as the bin number.