DayStar Digital Genesis MP User Manual
Also see for Genesis MP: Service guide
                                                                                | |
Contents
| 
Chapter 3 – Connecting Additional Peripherals Genesis MP46 u8. Install the bracket on your new nPOWER card by placing the card over the bracketand reinstalling the four Phillips head screws.9. Install the combined nPOWER card and bracket into Genesis MP by carefullyaligning the card over the nPOWER slot on the motherboard and then firmlypushing the card into the slot.Installing nPOWER Card10. Continue to support the card and screw the two hand screws on either side of thenPOWER card bracket into Genesis MP’s chassis.11. Reinstall Genesis MP’s side door panel by tightening down the four hand screws.Adding internal SCSI drivesGenesis MP was designed to make it extremely easy for you to add internal SCSIdevices. With its internal Fast SCSI-2 bus, internal SCSI devices can run up to twice asfast as those connected to the standard external SCSI bus. Genesis MP comes with a 1"high, 3.5" drive, with active termination, installed into the bottom drive bay.Standard ConfigurationGenesis MP was designed to support both 1" high and 1.6" high, 3.5" SCSI drives.Because 1.6" high devices take up roughly twice the space of a 1" high device, addinga 1.6" device blocks two 1" high bays.One empty 5.25 " baySix empty 3.5" baysSingle 3.5 " hard drive |
Related manuals for DayStar Digital Genesis MP
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine