DeLonghi 5500 Important Instructions Manual

Also see for Coffe Center 5500: Instruction manual Instructions

Contents

16Programming the quantity of coffeeand milk in the cup for cappuccinoor frothed milkThe appliance is factory preset to automaticallydeliver 2.4oz of frothed milk and 2.7oz of coffee.To modify these quantities, proceed as follows:1. Place a cup under the coffee spouts and thefrothed milk spout (fig. 19).2. Press and hold the CAPPUCCINO button for atleast eight seconds (fig. 22). The message"Milk for Cappuccino Program Quantity" isdisplayed.3. Release the button. The appliance starts run-ning off milk.4. Once the required quantity of milk has beenrun off into the cup, press the CAPPUCCINObutton again.5. After a few seconds, the appliance starts run-ning off coffee into the cup and the message"Coffee for Cappuccino Program Quantity" isdisplayed.6. Once the required quantity of coffee has beenrun off into the cup, press the CAPPUCCINObutton again. Coffee run-off stops and "READY"is displayed.The machine is now reprogrammed with the newquantities.Cleaning the milk container afteruseClean the internal tubes of the milk container eachtime you use it to avoid the build-up of milkresidues or blockages.Important! Danger of burns When cleaningthe internal tubes of the milk container, a little hotwater leaks out of the frothed milk tube (B5).Avoid contact with splashes of water.1 Place a cup or other container under thefrothed milk spout (B5 - fig. 19);2. Press the "CLEAN" button (B3 - fig. 20) and holdit down for at least eight seconds. The message"Cleaning" is displayed.3. Remove the milk container and clean the noz-zle with a sponge (fig. 21).HEATING WATERPreparationImportant! Danger of burns. Never leavethe machine unsupervised while running off hotwater. As shown below, stop run-off of hot waterwhen the cup is full. The hot water spout becomeshot while water is running off and must be han-dled by the handle only.1. Make sure the hot water spout (B7) isattached correctly (fig. 3).2. Place a container under the spout (as close aspossible to avoid splashes).3 Press the button (fig. 1). The message"Hot Water..." is displayed. Water runs out ofthe spout.NB! Stop the flow of hot water by pressingthe button.Important: You should not run off hotwater for more than two minutes at a time.Changing the quantityThe appliance is factory preset to automaticallydeliver 8.5oz. To modify these quantities, proceedas follows:1. Position a container under the spouts.2. Press and hold the button down for 8 sec-onds. The message "Hot Water ProgramQuantity" is displayed.• When the hot water in the cup reaches therequired level, press the button again.The machine is now reprogrammed with the newquantity.