DeLonghi BCO261CD Instruction Manual

4BCO261CDELECTRICAL REQUIREMENTSBefore using this appliance ensure that the voltage indicated on the product correspondswith the main voltage in your home, if you are in any doubt about your supply contact yourlocal electricity company.The flexible mains lead is supplied connected to a B.S. 1363 fused plug having a fuse of 13amp capacity.Should this plug not fit the socket outlets in your home, it should be cut off and replaced witha suitable plug, following the procedure outlined below.Note: Such a plug cannot be used for any other appliance and should therefore be properlydisposed of and not left where children might find it and plug it into a supply socket - withthe obvious consequent danger.N.B. We recommend the use of good quality plugs and wall sockets that can be switched offwhen the machine is not in use.IMPORTANT: the wires in the mains lead fitted to this appliance are coloured in accordancewith the following code:GREEN AND YELLOW EARTHBLUE NEUTRALBROWN LIVEAs the colours of the wires in the mains lead of this appliance may not correspond with thecoloured markings identifying the terminals in your plug, proceed as follows:- The wire which is coloured green and yellow must be connected to the terminal in theplug which is marked with the letter E or by the earth symbol or coloured green orgreen and yellow.- The wire which is coloured blue must be connected to the terminal which is marked withthe letter N or coloured black.- The wire which is coloured brown must be connected to the terminal which is markedwith the letter L or coloured red.When wiring the plug, ensure that all strands of wire are securely retained in each terminal.Do not forget to tighten the mains lead clamp on the plug. If your electricity supply point hasonly two pin socket outlets, or if you are in doubt, consult a qualified electrician.Should the mains lead ever require replacement, it is essential that this operation be carriedout by a qualified electrician and should only be replaced with a flexible cord of the samesize.After replacement of a fuse in the plug, the fuse cover must be refitted. If the fuse coveris lost, the plug must not be used until a replacement cover is obtained. The colour of thecorrect replacement fuse cover is that of the coloured insert in the base of the fuse recess orelsewhere on the plug. Always state this colour when ordering a replacement fuse cover.Only 13amp replacement fuses which are asta approved to B.S. 1362 should be fitted.This appliance conforms to the Norms EN 55014 regarding the suppression of radio inter-ference.Warning - this appliance must be earthedGreen and Yellow to Earth13 ampFuseBrown toliveCord ClampBlue toneutral