12NOTE 8: While the appliance is delivering coffee, never remove the water tank. If it is removed, theappliance will not be able to make the coffee.To reset the appliance, turn the steam knob anticlockwise as far as it will go and run off water from the cap-puccino frother for a few seconds.When using the appliance for the first time, 4-5 cups of coffee need to be made before the applian-ce starts to give satisfying results.If the appliance malfunctions, do not contact the service center right away.The problem can almost always be resolved by following the instructions indicated in paragraphs 14 and 15.If this is not the case, or for further explanations, contact the customer service by calling the number listed onpage 2.If your country is not listed on the sheet, call the number indicated on the warranty.6 CHANGING THE QUANTITY OF COFFEE IN THE CUPThe appliance is factory preset to automatically deliver the following quantities of coffee:- short (when the button is pressed);- standard (when the button is pressed);- long (when the button is pressed);To change these quantities, proceed as follows:- press the button corresponding to the quantity you want to change ( , or ) for at least5 seconds until the message "PROGRAM QUANTITY" is displayed;- when the coffee in the cup reaches the required level, press the same button again to memorize the newamount.7 REGULATING THE COFFEE MILLAfter making the first coffees, if you find that coffee delivery is either too fast or too slow (in drips), the grin-ding coarseness regulator can be adjusted (fig. 15).Turning it 1 click (1 number) clockwise speeds up coffee delivery (without drips).Turning it 1 click counter-clockwise slows down delivery giving a creamier appearance to the coffee.These adjustments will only be evident after at least 2 cups of coffee have been brewed.The grinding coarseness regulator must only be turned when the coffee mill is on.Turn counter-clockwise to obtain finer ground coffee, slowerdelivery and a creamier appearance.Turn clockwise for coarser ground coffee and faster delivery(not a drop at a time).(Coffee has been used to factory test the appliance and it is therefore completely normal for there to be tra-ces of coffee in the mill. This appliance is however guaranteed to be new).