31Check that the two red buttons have snapped out, otherwise the door cannot be closed.CORRECT INCORRECTThe two red buttons havesnapped outCORRECTLYThe two red buttons have notsnapped outNOTE 1: If the infuser is not inserted correctly until it clicks into place and the two red buttons have not snap-ped out, the service door cannot be closed.NOTE 2: If it is hard to insert the infuser, before inserting it squeeze it to the right size by pressing it force-fully from the top and bottom simultaneously, as shown in figure 28.NOTE 3: If it is still hard to insert the infuser, leave it out of the appliance, close the service door, unplug fromthe mains then plug in again.Wait for all the lights to go off, then open the door and replace the infuser.• replace the drip tray, complete with the grounds container;• close the service door.12 CHANGING AND SETTING THE MENU PARAMETERSThe following menu parameters and functions can be changed by the user:• Clock• Auto-start time• Descaling process• Coffee temperature• Length of time the appliance remains on• Water hardness• Factory default values• Washing process12.1 Setting the clockTo set the clock, proceed as follows:• Press the (the light over the button comes on) then press the button repeatedly until theappliance displaysCLOCK 00:00• Press the button to set the clock. (If you hold the , button down, the time is changedrapidly).• Press the button to confirm the value;• Press the button to exit programming mode or to change other parameters.12.2 Setting auto-start timeThis enables the time the appliance will come on automatically to be programmed.• Make sure the clock on the appliance is set as described above.• Press the button then press the button repeatedly until the appliance displays:START TIME 00:0002_GB-5732131000 4-10-2004 15:32 Pagina 31