DeLonghi ECAM 26.455.M Instructions For Use Manual

Contents

DeLonghi ECAM 26.455.M Instructions For Use Manual Manual pdf 16 page image

14Making drinks with milk automaticallyThe CAFFELATTE, CAPPUCCINO, MACCHIATO and MILK buttonson the control panel enable these drinks to be preparedautomatically.Proceed as follows:1. Fill the milk container and attach it as described above.2. Turn the froth adjustment dial on the milk container lid tothe position corresponding to the required froth.3. Press the button corresponding to the required drink.The name of the drink selected is displayed togetherwith a progress bar which gradually ills as preparationprogresses.4. After a few seconds, frothed milk is delivered from themilk spout into the cup below. For drinks with cofee, themachine automatically makes the cofee after deliveringthe milk.Please note!• If during delivery you want to stop preparation, press thecorresponding button.• At the end of delivery, to increase the quantity of milk orcofee in the cup, just press (within 3 seconds) the buttoncorresponding to the drink being made.• Do not leave the milk container out of the refrigeratorfor long periods. The warmer the milk (5°C is ideal), thepoorer the quality of froth produced.Cleaning the milk frother with the CLEAn button“Press CLEAN “ lashes on the display each time you use a milkfunction.To eliminate all milk residues, proceed as follows:1. Leave the milk container in the machine (you do not needto empty it);2. Place a cup or other recipient under the frothed milkspout.3. Press the CLEAN button (ig. 23) and keep pressing untilthe progress bar which appears on the display togetherwith the message “Cleaning underway” is complete.Please note!• If you are making a number of milk based drinks one afterthe other, you do not need to clean by pressing the CLEANbutton each time you make a cappuccino.Just press it once after making the last cup (the appliancecontinues functioning even if the CLEAN button is notpressed).Important!After use, always clean the hot water/steam nozzle and themilk container as described on page 14.programming the quantity of cofee and milk in thecup for the CAFFELAttE, CAppuCCino, MACChiAto andMiLK buttons.The appliance is set by default to automatically deliver standardquantities.To change these quantities, proceed as follows:1. Place a cup under the cofee and milk spouts.2. Press and hold one of the function buttons until themessage “Milk for … Program Quantity” is displayed.3. Release the button.The appliance starts delivering milk.4. Once the required quantity of milk has been delivered intothe cup, press the button again.5. The appliance stops delivering milk and (if required forthe drink being prepared) after a few seconds the cofee isdelivered into the cup. “Cofee for … Program Quantity”is displayed.6. Once the required quantity of cofee has been deliveredinto the cup, press the button.Cofee delivery stops.The machine is now reprogrammed with the new quantitiesof milk and cofee.dELiVErinG hot WAtEr And stEAMImportant! Danger of burns.Never leave the machine unsupervised while delivering hotwater or steam.The spout becomes hot during delivery. Hold by the handleonly.Please note!If “Energy Saving” mode is enabled, you may have to wait a fewseconds before the hot water or steam is delivered.delivering hot water1. Make sure the hot water spout is attached correctly (ig.6).2. Place a container under the spout (as close as possible toavoid splashes).3. Press the button (ig. 3).“Hot water” is displayed, together with a progress barwhich ills gradually as preparation proceeds.4. The machine delivers 250 ml of hot water, then deliverystops automatically.To interrupt delivery of hot water manually, press thebutton again.Change the quantity of water delivered automatically.The machine is set by default to automatically delivery 250 mlof hot water.