DeLonghi ONE On-Off 7K Operating And Installation Manual

Also see for ONE Inverter 12K: OPERATING AND INSTALLATION Manual

Contents

DeLonghi ONE On-Off 7K Operating And Installation Manual Manual pdf 14 page image

SINGLE SPLIT 13ENGLISHBefore starting installation, decide on the position of theindoor and outdoor units, taking into account the mini-mum clearance required around the units (see technicaldata table).Install the indoor unit in the room to be air conditioned,avoiding installations in corridors or communal areas.Install the indoor unit at a height of at least2.5 m from the ground.To install, proceed as follows:Installation of the mounting plate- Drill 32 mm deep holes in the wall for fixing the plate;- insert the plastic anchors into the hole;- fix the mounting plate using the self-tapping screws pro-vided;- check that the mounting plate is correctly fixed;- using a spirit level, check that it is level.Drilling a hole in the wall for the piping- Decide where to drill the hole in the wall for the piping(if necessary) according to the position of the mountingplate;- install a flexible flange through the hole in the wall tokeep the latter intact and clean.The hole must slope downwards towards the exterior.Installing the refrigerant, electrical and condensatedrainage pipes- Pass the pipe (for liquids and gas) through the hole inthe wall from the exterior or install it from the indo-or side, after having laid the pipes and connected thecables to the indoor unit, ready for connection to theoutdoor unit.Decide whether or not to remove the knockout accor-ding to the direction of the piping.Water connectionsBefore installing the air conditioner, choose the direc-tion for the pipes to exit; they may be arranged alongany one of the 4 directions shown in the figure:Ø 50 mmA2134knockoutProtective pipeOUTDOORSINDOORS2~5 cmNota: La vostra piastra di fissaggio può essere di formadiversa da quella sopra riportata, ma il metodo di installa-[JPOFÍTJNJMFThe outdoor unit must always be kept upright.Handling must be done by suitably equipped qualifiedtechnical personnel using equipment that is suitablefor the weight of the appliance.Carefully remove the adhesive strips from the applianceAfter having removed the packaging, check that thecontents are intact and complete.HANDLING USERINSTALLING THE INDOOR UNIT USER