23Height of outlet:within the range indicated by the dotted line in the figure below.When the unit is not in use, the outlet hole should be sealed with the stopper supplied.Temporary installation: The outlet holes can be connected in a number of ways:In any event, for maximum cooling efficiency the window should be closed as much as possible.It is advisable :— to keep the outlet free of any obstruction;— to lower the blind partially, without obstructing the outlet, thereby reducing exposure to direct sunlightand indoor/outdoor air exchange.ELECTRICAL CONNECTIONS— The mains supply, suitable for domestic electrical appliances, must correspond to the powerrequirements of the air conditioner (power consumption value shown in Table 1).— Check that the power supply voltage is: 220/240 V-50 Hz— Check that the mains socket is correctly earthed.Note: In the event that the plug supplied with the air-conditioner and complying with European regulations (EEC 7, VII) is not suitablefor your wall socket, make sure that it is replaced with a plug with a capacity of at least 10 A - 250 V (IMQ) that is also suitably earthed.Remove the power cable from the storage compartment at the back of the unit and plug it into the socket.THIS APPLIANCE IS MANUFACTURED TO COMPLY WITH THE RADIO INTERFERENCE REQUIRE-MENTS PROVIDED BY COUNCIL DIRECTIVE EN 55014.fixedhookmin.cm 30 max.cm 120