19TECHNICAL CHARACTERISTICS:Power supply voltageMaximum absorbed powerin air conditioningRefrigerantCooling capacitysee rating plate“““Limit conditionsRoom temperature for air conditioning 70÷95 °F(21÷35°C)GUARANTEEThe terms of the guarantee and technical assi-stance are given in the documentation accom-panying your appliance.Transport, filling, cleaning, recovery and disposal of refrigerant should be performed by a technicalservice centre appointed by the manufacturer only.The appliance should be disposed of by a specialist centre appointed by the manufacturer only.NEVER TRANSPORT OR TURN THE APPLIANCE UPSIDE DOWN OR ON ITS SIDE. IF THIS OCCURS,WAIT 6 HOURS BEFORE TURNING THE APPLIANCE ON, 24 HOURS IS RECOMMENDED. (After theunit has been on its side, oil needs to return to the compressor to ensure proper function. Withoutallowing the unit this time (6-24 hours) The unit may function for only a short time, and then thecompressor will break down from lack of oil).This appliance is equipped with a 3 prong grounded plug. The plug must be connected into an outletthat is properly installed and grounded in the accordance with all local codes and ordinances. Do notmodify the plug provided with the appliance. If it will not fit the outlet, have a proper outlet installedby a qualified electrician or relocate the unit to a proper outlet.If the household electrical supply does not meet the above specifications, or if you are not sure yourhome has an effective electrical ground, have a qualified electrician or your local electrical utilitycompany check it and correct any problems.SAfETY PLUGThe appliance is fitted with a safety plug to protect the power cable.If power is cut off, unplug from the outlet and make sure the power cable is undamaged.If the cable is damaged, call the service center immediately.If power cuts off frequently and the power cable is undamaged, contact a qualified electrician.OPERATION Of THE SAfETY PLUGIf the safety device incorporated in the plug trips and cuts off the power supply, check that the powercable and plug are not damaged.If the power cable is undamaged, to restore operation press the “RESET” button.To verify correct operation of the plug, press the “TEST” button periodically and make sure the ap-pliance disconnects. If this is not the case, contact the service center.To restore operation, press the “RESET” button.