DeLonghi PALACE Instruction And Installation Booklet

18Some parts of this product can become very hot and cause burns.Particular attention has to be given where children andvulnerable people are present.CAUTION!!!INSTALLATION[Fig. 1]Carefully read all of the instructions and measuresfor correct installation of the radiator.Make the electrical connections only after fixing the radiator to the wall.•with the regulations in force and using certified materials.The connections must only be made by qualified and expert personnel in compliance•application. Do not try to replace this cable with any other inappropriate cable.any problems, contact your dealer. The cable supplied is made specifically for theDo not try to manipulate the radiator’s body or the electrical boxes. If you encounter•completely cuts off under the conditions covered by overvoltage category III.that ensures omnipolar disconnection of the mains, with a contact opening gap, thatIn compliance with the installation rules, a switch must be provided in the power supply unit•power release device or a properly sized contactor.command or control system (thermostat switch or control contact), insert aIf the radiator load is higher than that indicated on the data plate of the•The appliance’s power supply circuit must be protected;•For appliances without a socket, follow these colours:•L N Bphase (brown) neutral (blue or grey) Fil pilot (black)CAUTION!!!The “FIL PILOT” is intended for radiators connected to the energy managementunit/chronothermostat. If the black “FIL PILOT” is not used, the safety rulesrequire it to be insulated and not be connected to the earth wire.- A disconnect switch is mandatory.- All contacts must be separated by at least 3mm.- It is mandatory for the power supply system to which the controller is connected to have an extra-sensitive differential protection.- In the bathroom, it can be installed in zone 3 (see figure 1) provided that the control device cannot beused by people while using the shower or bath.- The power cable must be connected to a socket or connection block, which must be at least 25 cm offthe ground (without intermediate plugs) for devices sold without plugs.