DeLonghi PALACE Instruction And Installation Booklet

1) Drill the wall considering Lf [hole length] and Hf [hole height]. [Fig. 6]2) Screw in the 4 rails.3) Fix the two top wall brackets facing upwards (the screws must be inserted in the bracket,but not fully screwed). [Fig. 7 A and B]4) Insert a bottom wall brackets facing downwards (the screws must be inserted in the bracket,but not fully screwed). [Fig. 7 C and D]5) Mount the radiator by attaching it to the two top brackets.6) Insert the two bottom wall brackets between the radiator’s elements.7) Tighten all of the screws.[Fig. 3;4; 5] Install the radiator 20 cm off the ground. The product is notto be recessed. If installed near a wall, respect the minimumdistance of 10 cm to the left. As the thermostat is fixed to theright, the distance from the wall on the right must be at least 30 cm.Length of the side cable: 1.60 mWALL MOUNTING INSTRUCTIONSFix the bottom wall brackets in the opposite directionto stop the radiator from turning over.MAINTENANCE20CHARACTERISTICS OF THE APPLIANCE:appliance protected against water jets.Class II: double insulation• If the supply cord is damaged, it must be replaced by the manufacturer, its service agentor similarly qualified persons in order to avoid a hazard.• If there is a fault, contact your dealer. Do not alter the product in any way;any disassembly or any opening compromises the safety of the product.We do not accept any liability for accidents due to any kind of manipulation carried out onthe electrical appliance.• Do not intervene on the appliance during operation.• Before cleaning it in any way, make sure that the electric radiator is at room temperatureand the circuit is disconnected.• Clean with a damp cloth without using aggressive or abrasive cleaning products that couldcompromise the appliance’s coating.[Fig. 6; 7;8a; 8b]