HOW TO USE THE TIMERTo program heating, proceed as follows (fig.7):- Look at the time on your clock or watch. If it is 10 p.m.,turn the numbered timer disk clockwise until the num-ber 22 (10 p.m.) on the disk coincides with the pointers (3) on the timer. Set the periods of time when youwant the appliance to work by pushing the teeth (1)inward.Each tooth (1) corresponds to a period of 15 minutes.This will leave visible sectors which correspond to theperiods of operation (2). When set, the radiator willoperate automatically each day during the times pro-grammed (important: the radiator must always beplugged into the socket).- To change the programming, move the teeth back intothe initial position and set the new periods of operation.- To turn the appliance off completely, as well as press theswitches to the 0 position, you must also unplug it fromthe power outlet to avoid continued operation of thetimer.IMPORTANT: DO NOT ROTATE CLOCK DIAL COUNTER-CLOCKWISE.The timer is like an electric clock, and will only work whenplugged into a power supply. When unplugged, the timerstops and must be later re-set.Timer override (only on some models)If you wish to override the timer settings, push the timerswitch to position I (fig.8) manual (timer override). To returnto timed operation push the switch back to the middle posi-tion (fig.8).NOTE: if the timer switch is at the 0 position (fig. 8),the heater is off and will not operate).MAINTENANCEBefore carrying out any operation on the radiator, unplugfrom the electric mains and wait for it to cool.The oil-filled electric radiator requires no particular mainte-nance. It is sufficient to remove the dust with a soft, dry cloth.Never use abrasive powders or solvents. If necessary removeconcentrations of dirt using a vacuum cleaner.TECHNICAL CHARACTERISTICSPower supply See rating labelAbsorbed power āTROUBLESHOOTINGPROBLEM CAUSE SOLUTIONThe appliance doesn't work Be sure it is plugged in and that the elec-trical outlet is working.Check for any obstruction.The temperature may be set too low.Plug into the power outlet.Remove the obstruction and let the appli-ance cool down. If the appliance doesn't workplease contact Customer Experience.Set the temperature to a higher position.12