Dedicated Micros 2060 Operation Manual

Also see for 2060: Operation manual Quick start guide Installation manual System manual MENU SYSTEM MANUAL

Dedicated Micros 2060 Operation Manual Manual pdf 22 page image

Dedicated Micros ©2009 2060Alternative ControllersIt is possible to control the Dedicated Micros 2060 dome from a wide range of controller devices. Always referto the controller manual to identify the correct operating procedures. The following pages describe the settingsand key sequences to control the domes from some of the most common controllers. However, subsequentchanges in controller and keyboard design and operation may mean that these notes become incorrect.Dedicated Micros DS2Up the coax controlThe controller PTZ protocol must be configured as follows:-● Dedicated Micros ‘Camera Setup’ Menu set to ‘Coax:Dennard-C’.● Dome address switches set to ‘FD’, Refer to the Operation/Installation Manual, suppliedwith each Dome.Blue rotary address switch set to F…. Yellow rotary address switch set to DSTORING PRESET POSITIONS:Note: In this configuration, it may be quicker to use the DM controller software rather than using the Domesoftware.1. Move the camera to the desired position then press, and hold, the ‘Preset’ key until “Savepreset” or “Enter preset number” appears on the screen.2. Enter the preset number using the number keys and press ‘Enter’. The numbers areentered as normal for presets 1 to 9 but, to access preset 10 enter ‘1’ then ‘10’. Presetnumbers 1 – 16 are accessed by entering them as single digits (i.e. ‘1’ then ‘1’ for 11; ‘1’then ‘6’ for 16).3. If the dome is being controlled by the ‘up the coax’ method, preset positions greater than 17can be programed using the dome menu. At this stage the preset menu from the dome willbe displayed on the screen enabling a preset identification to be keyed in. This alternativemethod is not necessary the dome is controlled by the Dennard RS485 method).Text can be entered by moving the cursor under each letter/number in turn and using thejoystick, then pressing the preset,1, enter key to accept.4. When text entry is complete, close the menu by moving the cursor down to the Accept editline and accept by pressing the ‘preset’, ‘1’, ‘enter’ keys.On the DS2 there are two enter/accept commands.1. Press the preset key until “go to position” is shown on the screen then press key 1 then theenter key i.e. preset,1, enter.2. Press just the enter key.DOME PROGRAMING:There are two methods to access the dome menus:1. For systems set up for 485 control or with Sprite systems dating from mid-2004 onwards,configured for Dedicated Micros C coax control, press the * key.2. For older systems using coax control, the following key presses are used:For the Operator menu press: * 8 8 9 10 10 2For the Supervisor menu press: * 8 8 9 10 10 3For the Technician menu press: * 8 8 9 10 10 4The Operator menu will then be displayed enabling menu navigation using the joystick to move the cursor andpressing the ‘enter’ key to accept menu options.