Part Number: 9291455 08/17 7DANGERInstallation must comply with all applicable fire andhealth codes in your jurisdiction.,CautionWhen adding any item verify the location of therefrigeration lines on wrapped rail units. A refrigerationleak in a rail may be irreparable or extremely difficult andcostly to repair.LocationnWarningThis equipment must be positioned so that the plug isaccessible unless other means for disconnection from thepower supply (e.g., circuit breaker or disconnect switch)is provided.nWarningAdequate means must be provided to limit the movementof this appliance without depending on or transmittingstress to the electrical conduit or gas lines.nWarningTo avoid instability the installation area must be capableof supporting the combined weight of the equipmentand product. Additionally the equipment must be levelside to side and front to back.nWarningThis equipment is intended for indoor use only. Do notinstall or operate this equipment in outdoor areas.The location selected for the equipment must meet thefollowing criteria. If any of these criteria are not met, selectanother location.• Units are intended for indoor use only.• The location MUST be level, stable and capable ofsupporting the weight of the equipment.• The location MUST be free from and clear of combustiblematerials.• Equipment MUST be level both front to back and side toside.• Position the equipment so it will not tip or slide.• Front casters MUST be locked once positioned.• Recommended air temperature is 50° - 100°F(10° - 38°C).• Proper air supply for ventilation is REQUIRED ANDCRITICAL for safe and efficient operation.• Do not obstruct the flow of ventilation air. Make sure theair vents of the equipment are not blocked.• Do not install the equipment directly over a drain. Steamrising up out of the drain will adversely affect operation,air circulation, and damage electrical / electroniccomponents.Section 2Installation