Delfield Shelleymatic N-1200 Specifications

Also see for Shelleymatic N-1200: Service and installation manual

Delfield Shelleymatic N-1200 Specifications Manual pdf 1 page image

PROJECTITEM #QUANTITY DATEAPPROVALThe Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.comDelfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.Short Form SpecificationsExterior sides shall be 20-gauge stainless steel. Top and corner supports shall be16-gauge stainless steel, welded, ground and polished into one integral unit.Inner liner shall be water-tight and constructed of 22-gauge stainless steel with1.25” (3.2cm) I.P.S. drain. Unit shall be insulated with high-density, foamed in placepolyurethane insulation with a non-conductive to breaker strip.Each opening shall have a stainless steel sliding lid with recessed handles.(3) stainless steel louvers shall be installed in the end and sides of the cabinet toallow proper air flow to the condensing unit.each self-leveling mechanism shall be field adjustable by adding or removing stainlesssteel extension springs in the elevator housing inside the unit. The elevators shall beconnected by removable platform carriers constructed of 18-gauge stainless steel.(6) anodized aluminum divider trays will be supplied per deep cabinet section. (2)anodized aluminum divider trays will be supplied per deep cabinet section over themachine compartment. NOTE: See chart on back for milk storage capacity.Refrigeration system shall use HFC-134a refrigerant. Refrigerant flow shall be con-trolled by an expansion valve. Cabinet shall maintain 36°F to 40°F (2°C to 4°C)temperature with lids closed for storage.Refrigeration system shall be controlled by a pressure control, located near thecondensing unit.Electrical connections shall be 115 volt, 60 cycle, single phase. Unit shall have a 9’(2.7m) long electrical cord and NEMA 5-15P plug.Unit shall be mounted on 6.00” (15.2cm) high adjustable stainless steel legs.Optional Accessories and Modifications• 4.00” (10.2cm) diameter swivel casters (all locking) with corner bumpers(adds 2.50” (6.4cm) to overall length and depth and reduces overall heightby 1.00” (2.5cm)• Heavy-duty casters (contact factory)• Corner bumpers (adds 2.50” [6.4cm] to overall length and depth)• Wrap-around bumpers (adds 1.75” [4.4cm] to overall length and depth)• Wire baskets (13.81” x 11.62” x 3.87” [35.1cm x 29.5cm x 9.8cm])• Laminate panels• Fiberglass panels• Lid locking device• Special voltages (consult factory)Model N-860shown with optional casters andwrap-around bumpersNOTE: This equipment is intended for storage and /or display of pre-packaged or bottled products only.Free-Standing Self-Contained Milk or Beverage DispensersN

/ 2

Related manuals for Delfield Shelleymatic N-1200