Delfield Shelleymatic T-1221H Specifications

Also see for Shelleymatic T-1014: Install guide

Delfield Shelleymatic T-1221H Specifications Manual pdf 1 page image

Short form specificationsCabinet top shall be 16-gauge stainless steel with all cornerswelded, polished and reinforced with heavy-gauge channels.Cabinet exterior panels shall be 20-gauge stainless steel.Bottom shall be 14-gauge galvanized steel. Unit shall have (4)4.00” (10.2cm) diameter polyolefin swivel casters (all locking),and non-marking gray bumpers at each corner.Dispenser platform carrier shall be 18-gauge stainless steeland shall be removable for cleaning. Each dispenser shall befield adjustable by adding or removing stainless steel extensionsprings located inside the elevator housing.THE FOLLOWING APPLIES TO T/T2-H HEATED DISPENSERSONLY:Heated dispensers shall have a stainless steel liner separatedfrom the outer panels by 2.00” (5.1cm) of fiberglass insulation.Unit shall be supplied with 9’ (2.7m) cord and plug as shown inthe specifications table on reverse. Electrical connections shallbe 120 volt, 60 hertz, and single phase.Dispenser shall have one or two convection heating modulesconsisting of a single 700-watt heating element and fan motor,located in the center of the interior bottom cavity. Models1014-1422 shall have one module; larger models have twomodules. Air intake shall have a filter. Dispenser shall have anadjustable thermostat and an ON/OFF switch on the side of theunit. Unit shall maintain a temperature between 150°F-170°F(66°C-77°C).Mobile enclosed tray and rack dispensersPROJECTITEM #QUANTITY DATEAPPROVALTMODEL TG-1216The Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.comDelfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.Optional Accessories & Modifications• Heavy-duty caster (consult factory)• Flange-mount feet in lieu of casters• Special tray dispenser sizes• Six- or eight-hole silverware bins withplastic or stainless steel cylinders• Additional plastic or stainless steelsilverware cylinders• Wrap-around bumpers (adds 1.75”[4.4cm] to overall length and depth)• Fiberglass panels• Laminate panels• Special tray & rack sizes• Special height

/ 2

Related manuals for Delfield Shelleymatic T-1014