Delfield Shelleymatic RFFSC-103 Specifications
Also see for Shelleymatic RFFSC-103: Service and installation manual
  |
PROJECTITEM #QUANTITY DATEAPPROVALThe Delfield Company, 980 S. Isabella Rd., Mt. Pleasant, MI 48858, U.S.A. • (800) 733-8821 • Fax (800) 669-0619 • www.delfield.comDelfield reserves the right to make changes in design or specifications without prior notice. ©2002 The Delfield Company. All rights reserved. Printed in U.S.A.RFFSCBuilt-in self-contained milk & ice cream dispensersShort form specificationsThe exterior sides and top edge shall be 20-gauge galvanized steel.Exterior bottom to be 14-gauge galvanized steel.Interior shall have (2) separate compartments, one refrigerated and onefreezer. Inner liners shall be water-tight and constructed of 22-gaugestainless steel with a 1.25" (3.2cm) I.P.S. drain. Openings shall havethroat liners constructed of high impact plastic. Unit to be insulatedwith foamed-in-place polyurethane insulation with a non-conductive topbreaker strip.Each opening shall have an insulated, stainless steel folding lid withhigh impact plastic liner, molded rubber edge and black plastic handles.(1) stainless steel louver shall be provided for installation in the cabinetto allow proper air flow to the condensing unit.Each self-leveling mechanism shall be field adjustable by adding orremoving stainless steel extension springs in the elevator housing insidethe unit. The elevators shall be connected by removable platform carriersconstructed of 18-gauge stainless steel.(6) anodized aluminum divider trays will be supplied per opening.NOTE: See chart on back for ice cream storage capacity.Refrigeration system shall use HFC-404A refrigerant. Refrigerant flowshall be controlled by an (2) expansion valves. Cabinet shall maintain36°F to 40°F (2°C to 4°C) temperature in the refrigerator section and0°F to 5°F (–18°C to –15°C) temperature in the freezer section with lidsclosed for storage.Refrigerator section shall be controlled by an EPR valve; the freezersection shall be controlled by a pressure control. Controls shall belocated near the condensing unit.Electrical connections shall be 115 volt, 60 cycle, single phase. Unitshall have a 9' (2.7m) long electrical cord and NEMA 5-15P installed atthe mechanical end.Optional accessories & modifications• Lid locking device• Wire baskets• Lexan® lids (refrigerated compartment only)• Inclusion of this option will alter the electrical specifications of theunit. Special voltages (contact factory)This equipment is intended for storage and/ordisplay of pre-packaged or bottled products only.Model RFFSC-103 |
Related manuals for Delfield Shelleymatic RFFSC-103
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine