Dell 1125 Mono Laser MFP User Manual

Contents

Adjust Resolution to alter faxed document image quality depending on requirements:l Standard - the default setting designed for documents with normal sized charactersl Fine - designed for use with documents containing small or fine characters or documents printed using a dot-matrix printerl Super Fine - designed for use with documents containing extremely fine detail.See the following guide to temporarily adjust fax Resolution.1. Press Scroll (<>) to select Fax and press Select (P).2. Press Scroll (<>) to select Quality Settings and press Select (P).3. Press Scroll (<>) to select Resolution and press Select (P).4. Press Scroll (<>) to select Standard, Fine, or Super Fine and press Select (P).5. Transmit fax as normal (see Sending a Fax Automatically and Sending a Fax Manually).6. Press Cancel (V) to return to the Standby mode.Adjusting the Document ContrastAdjusting Contrast causes faxed documents to appear lighter or darker, depending on requirements:l Normal - the default settings designed for use with standard typed or printed documentsl Darker - designed for use with light print or faint pencil markingsl Lighter - designed for use with dark printSee the following guide to temporarily adjust fax Contrast.1. Press Scroll (<>) to select Fax and press Select (P).2. Press Scroll (<>) to select Quality Settings and press Select (P).3. Press Scroll (<>) to select TX Contrast and press Select (P).4. Press Scroll (<>) to select Normal, Darker, or Lighter and press Select (P).5. Transmit fax as normal (see Sending a Fax Automatically and Sending a Fax Manually below).6. Press Cancel (V) to return to the Standby mode.Sending a Fax AutomaticallySee the following guide to automatically send a fax.1. Load the document(s) face up with top edge first into the ADF (see Using the Automatic Document Feeder (ADF)).ORPlace a single document face down on the scanner glass (see Using the Scanner Glass).2. Adjust the document contrast and resolution to suit your fax needs (see above).3. Enter the remote fax phone number using the keypad.4. Press Start (u). When the document is loaded from the scanner glass, the message, Another Page? appears on the top line of the display after thedocument is scanned into the memory. For more than one page, remove the scanned page, load the next page on the glass and select Yes. After all ofNOTE: The Super Fine mode is only available if the remote printer also supports the Super Fine resolution. Faxes scanned in Super Fine resolutiontransmit at the highest resolution supported by the receiving device.NOTE: The Contrast menu applies changes to the next fax only. Default fax settings are reapplied after the fax is sent.NOTE: You can also use one or two-digit speed or group dial numbers. For more information, see Automatic Dialing.