Printer MaintenanceThe Printer Maintenance tab includes the System Settings, Clock Settings, Paper Density, Registration Adjustment, Adjust Altitude, Reset Defaults, Non-Dell Toner, Initialize PrintMeter, Web Link Customization, TCP/IP Settings, Tray Settings, EWS, Scan Defaults, Fax Defaults, Copy Defaults, and FaxSettings pages.System SettingsPurpose:To configure the printer's power management, auto clear time, alarm tones, time-out time, mm/inch setting, job log auto print, position of the Print ID, settingof the dump print, setting of the additional memory, setting of the substitute sheet, and operator panel language settings.Values:Country Displays the country where the printer is used.NOTE: Values marked by an asterisk (*) are the factory default menu settings.Power SaverTimer ModePower Saver TimerMode 1*15-60 minutes Specifies the time before the printer enters the power saver timer mode 1(sleepmode) after it finishes a job.5 minutes*Power Saver TimerMode 2*11-6 minutes Specifies the time before the printer enters the power saver timer mode 2 (deepsleep mode) after it finishes a job.6 minutes*Auto Reset45 seconds*Specifies the time before the printer automatically resets the settings on theoperator panel to the defaults when no additional settings are made.1 minute2 minutes3 minutes4 minutesAlert TonePanel SelectToneLowEmits a tone at the specified volume when the operator panel input is correct.MediumHighOff* Does not emit a tone when the operator panel input is correct.Panel AlertToneLowEmits a tone at the specified volume when the operator panel input is incorrect.MediumHighOff* Does not emit a tone when the operator panel input is incorrect.Machine ReadyToneLowEmits a tone at the specified volume when the printer becomes ready.Medium*HighOff Does not emit a tone when the printer becomes ready.Copy Job ToneLowEmits a tone at the specified volume when copying is complete.Medium*HighOff Does not emit a tone when copying is complete.Non-Copy JobToneLowEmits a tone at the specified volume when any other job except copying iscomplete.Medium*HighOff Does not emit a tone when any other job except copying is complete.Fault ToneLowEmits a tone at the specified volume when a job ends abnormally.Medium*HighOff Does not emit a tone when a job ends abnormally.Alert ToneLowEmits a tone at the specified volume when a problem occurs.Medium*HighOff Does not emit a tone when a problem occurs.Out of PaperToneLowEmits a tone at the specified volume when the printer runs out of paper.Medium*HighOff Does not emit a tone when the printer runs out of paper.Low
