94 Installing Printer Drivers on the Windows ComputersFILE LOCATION: C:\Users\fxstdpc-admin\Desktop\0630_UG??\Mioga_SFP_UG_FM\Mioga_SFP_UG_FM\section10.fmD E L L C O N F I D E N T I A L – P R E L I M I N A RY 9 / 1 3 / 1 0 - F O R P R O O F O N LYThe Tool Box opens.2 Ensure that the Printer Settings Report tab is open.3 Select TCP/IP Settings from the list at the left side of the page.The TCP/IP Settings page appears.If the IP address shows 0.0.0.0 (the factory default), an IP address has notbeen assigned. To assign one for your printer, see "Assigning an IP Address."Disabling Firewall Before Installing Printer SoftwareNOTE: This step is necessary if you have Windows XP Service Pack 2 or 3installed.If your printer is connected directly to a network, and the Windows XP,Windows Vista, Windows Server 2008, Windows Server 2008 R2, or Windows7 firewall is enabled, you cannot view your networked printer(s) when you runthe Dell printer installation software. To prevent this situation, disable thisfirewall before you install the Dell printer software. To disable or enable yourWindows XP, Windows Vista, Windows Server 2008, Windows Server 2008 R2,or Windows 7 firewall, perform the following steps.1 Click Start and click Help and Support.NOTE: For Windows Server 2008 R2 and Windows 7, if you use OnlineHelp, switch to Offline Help on Windows Help and Support window.2 In the Search box, type firewall, and then press the Enter key.In the list, click Turn Windows Firewall on or off, and then follow theinstructions on the screen.Inserting the Drivers and Utility CD1 Insert the Drivers and Utilities CD into your computer and clicksetup_assist.exe to start Easy Setup Navigator.NOTE: If the CD does not launch automatically launch, follow theprocedure below.For Windows XP, Windows Server 2008, and Windows Server 2008 R2Click start Run, enter D:\setup_assist.exe (where D is the CD driveletter) in the Run dialog box, and then click OK.For Windows Vista and Windows 7Downloaded from ManualsPrinter.com Manuals
