Dell 2200F User Manual
                                     | |
Contents
| 
A-2 QLA2xxx User’s Guide• Host Adapter BIOS. When this setting is disabled, the ROM BIOS on the QLA2xxx board isdisabled, freeing space in upper memory. Do not disable this setting if you are booting from anFC disk drive attached to the QLA2xxx board. The default is Disabled.• Frame Size. This setting specifies the maximum frame length supported by the QLA2xxxboard. The default size is 1024.• Loop Reset Delay. After resetting the loops, the firmware refrains from initiating any loopactivity for the number of seconds specified in this setting. The default is 5 seconds.• Adapter Hard Loop ID. This setting forces the adapter to use the ID specified in the HardLoop ID setting. The default is Disabled.• Hard Loop ID. If the Adapter Hard Loop ID setting is enabled, the adapter attempts to use theID specified in this setting. The default ID is 0.Advanced Adapter SettingsFrom the Configuration Settings menu in Fast!UTIL, select Advanced Adapter Settings. Thedefault setting for the QLA2xxx host adapter board is listed in table A-2 and described in the follow-ing paragraphs.• >4GByte Addressing. This option should be enabled if the system has more than 4 gigabytes(GB) of memory available. The default is Disabled.Scan Fibre Channel DevicesThis option scans the FC loop and lists all the connected devices by loop ID. Information about eachdevice is listed, for example, vendor name, product name, and revision. This information is usefulwhen configuring your QLA2xxx board and attached devices.Select Host AdapterUse this setting to select a specific QLA2xxx board if you have multiple QLA2xxx boards in yoursystem.Hard Loop ID 0-125 125Table A-2. Advanced Adapter SettingSetting Options Default>4GByte Addressing Enabled or Disabled DisabledTable A-1. Host Adapter Settings (continued)Setting Options Default |
Related manuals for Dell 2200F
This manual is suitable for:
manualsdatabase
Your AI-powered manual search engine