Dell 2408WFP User Manual

Also see for 2408WFP - UltraSharp - 24" LCD Monitor: Setup guide Datasheet Specifications

Dell 2408WFP User Manual Manual pdf 19 page image

Using the OSD Menu1. Push the MENU button to launch the OSD menu and display the main menu.Main Menu for Analog (VGA) InputBPIP/PBP SelectUse this button to activate PIP (Picture-in-Picture)/PBP (Picture-by-Picture) modes adjustment.Pressing this button continually cycles the monitor through the following modes : OFF-->PIP-->PBP. You will see the following messagescorresponding to the mode selected.→→COSD Menu/SelectThe Menu button is used to open and exit the on-screen display (OSD), and exit from menus and sub-menus. See Using the OSD MenuDBrightness /ContrastHot KeyUse this button for direct access to the "Brightness" and "Contrast" control menu.DandEDown (-) and Up (+)Use these buttons to adjust (decrease/increase ranges) items in the OSD menu.EAuto AdjustUse this button to activate automatic setup and adjustment. The following dialog appears on a black screen as the monitor selfthe current input:Auto Adjustment button allows the monitor to self-adjust to the incoming video signal. After using Auto Adjustment, you can furthertune your monitor by using the Pixel Clock (Coarse), Phase (Fine) controls in the OSD.NOTE: Auto Adjust does not occur if you press the button while there are no active video input signals or attached cables.FPower button(with power lightindicator)Use the power button to turn the monitor on and off.The green light indicates the monitor is on and fully functional. An amber light indicates power save mode.NOTE: If you change the settings and then either proceed to another menu, or exit the OSD menu, the monitorautomatically saves those changes. The changes are also saved if you change the settings and then wait for theOSD menu to disappear.